求西门子840D五轴系统后处理，主要是前后缀，能帮修改NX12.0的后处理更好，谢谢大...

qiqi自学UG

N15 TRAFOOF
N16 FFWON
N17 SOFT
N18 G645
N19 T12
N20 M6
N21 ;-------------------------
N22 SUPA G0 Z=$AA_SOFTENDP[Z]-0.6
N23 SUPA G0 Y=$MA_POS_LIMIT_PLUS[Y]-0.6
N24 F_Free_After_M6
N25 M91 M93
N26 ClampingDeviceFunc(1,1,1,1,1,1,1,1)
N27 CURTAINS_DOWN
N28 CUT2DF
N29 G0 G54 A0 C0
N30 ;-------------------------
N31 S8000 M3
N33 TRAORI(1)
N34 G54 G90 D1
N35 TRANS
N36 ROT
N37 M91
N38 M93
N39 ATRANS X0.0 Y0.0 Z0.0
N40 G0 A0.0 C0.0
N41 M90 M92
N42 AROT Z0.0
N43 AROT Y0.0
N44 AROT X0.0
N45 ORIWKS
N46 ; =========
N47 ; TOOLPATH  : 2
N48 ; WORKPLANE : G54
N49 ; =========
N50 M8


N160 G0 X-39.142 Y819. C0.0 A0.0
N180 G90 Z109. S3000 M3
N190 G94 F300.
N200 MCALL CYCLE83(109.,0.,3.,-63.1545,,,1.4687,0.,,,1.,1,,0.)
N210 X-39.142 Y819.
N220 Y519.
N230 Y219.
N240 X-150. Y40.
N250 X-600.
N260 X-1000.
N270 X-1600.
N280 X-2000.
N290 X-2450.
N300 X-2560.858 Y219.
N310 Y519.
N320 Y819.
N330 MCALL
N340 M5
N350 M9

N378 M5
N379 M9
N380 M91
N381 M93
N382 TRAFOOF
N383 SUPA G0 Z=$AA_SOFTENDP[Z]-0.6
N384 SUPA G0 Y=$MA_POS_LIMIT_PLUS[Y]-0.6
N385 F_Free_After_M6
N386 SUPA G90 G0 A0 D0
N387 SUPA G90 G0 C0 D0
N388 CURTAINS_UP;( OPEN DOOR)
N389 ;---------------
N390 M30
%