求助PowerMill后处理器错误–Failed to get translator version from registry

df871303789

新手一个   后处理错误不知道怎么解决后处理器错误–Failed to get translator version from registry

zhangbo0372

zhangbo0372 发表于 2023-4-1 11:01
"Failed to get translator version from registry" when writing NC programs in PowerMill

Autodesk S ...

到https://www.autodesk.com/support ... y-in-PowerMIll.html
下载DuctPost_1.zip;重新安装

zhangbo0372

"Failed to get translator version from registry" when writing NC programs in PowerMill

Autodesk Support

Jun 1, 2022

Issue:
PowerMill fails to write NC programs. Getting error: "Failed to get translator version from registry", after installing software on a new PC or removing legacy versions. Sometimes, PowerMill will close after the error message is populated.

One or both following error are displayed:
PowerMill Error:
Postprocessor Error - Failed to get translator version from registry.

PowerMill Error: Failed to get translator version from registry
PowerMill Error:
           Postprocessor Error - Failed to get translator version from registry. Please ensure that Autodesk                               Manufactoring Post Processor Utility is installed and that it has been registered correctly.

zhangbo0372

"Failed to get translator version from registry" when writing NC programs in PowerMill

Autodesk Support

Jun 1, 2022
Issue:



PowerMill fails to write NC programs. Getting error: "Failed to get translator version from registry", after installing software on a new PC or removing legacy versions. Sometimes, PowerMill will close after the error message is populated.

One or both following error are displayed:
PowerMill Error:
Postprocessor Error - Failed to get translator version from registry.

PowerMill Error: Failed to get translator version from registry
PowerMill Error:
           Postprocessor Error - Failed to get translator version from registry. Please ensure that Autodesk                               Manufactoring Post Processor Utility is installed and that it has been registered correctly.
重新安装DuctPost就可以