|
|
发表于 2024-10-28 17:32:58
|
显示全部楼层
Multi_coordinates : 0 # 开启多工位，多坐标选择？（利用宏代码循环指令多工位多坐标系加工,最多48个）
# 0 = 关闭多工位，多坐标
# 1 = 开启多工位，多坐标(数量小于7个使用标准坐标系G5N，大于6个使用附加坐标系G54.1 PN)
# (开启时在对话框输入数量小于2个或直接回车 = 软件设置的坐标系)
fmt "P" 4 dwellda #G54.1坐标系P代码
coordinate : 0
le_number : 0
sav_spc1 : 0
hzbscbj : 0
fmt "LE" 4 le_number
pcoordinate
if sjyxbj = 1238 & sydgx = 2589 & sfzmdl = 1579,
[
if Multi_coordinates = 1,
[
if hzbscbj = 0, q1, hzbscbj = 1
if coordinate > 1 & coordinate < 7,
[
sav_spc1 = spaces$
spaces$ = 0
le_number = coordinate + 53
pbld, "#1=54", e$
pbld, "WHILE[#1", *le_number,"]", "DO1", e$
spaces$ = sav_spc1
]
else,
if coordinate > 6,
[
if coordinate > 48, coordinate = 48
sav_spc1 = spaces$
spaces$ = 0
le_number = coordinate
pbld, "#2=1", e$
pbld, "WHILE[#2", *le_number,"]", "DO1", e$
spaces$ = sav_spc1
]
]
]
fq 1 coordinate "请输入坐标数量后按回车键确认!大于6个使用G54.1PN坐标系，输入数量小于 2 或直接回车确认等于软件默认坐标系(支持6个标准和48个附加坐标系)"
pcoordinate1
if sjyxbj = 1238 & sydgx = 2589 & sfzmdl = 1579,
[
if Multi_coordinates = 1,
[
if coordinate > 1 & coordinate < 7,
[
sav_spc1 = spaces$
spaces$ = 0
pbld, "#1=#1+1", e$
pbld, "END1", e$
spaces$ = sav_spc1
]
else,
if coordinate > 6,
[
sav_spc1 = spaces$
spaces$ = 0
pbld, "#2=#2+1", e$
pbld, "END1", e$
spaces$ = sav_spc1
]
]
]
pwcss
if sjyxbj = 1238 & sydgx = 2589 & sfzmdl = 1579,
[
[if Multi_coordinates = 1 & coordinate > 1 & coordinate < 7, "G#1"],
[if Multi_coordinates = 1 & coordinate > 6 , "G54.1 P#2"],
[if Multi_coordinates = 0 | coordinate < 2, pwcs],
] |
|
