ug后处理求助

henry1268

我在后处理中加入如下信息，但会出现报警，请大神出手解决，目的是钻头可以出钻尖角度。谢谢！

global mom_tool_name mom_tool_type
global mom_tool_diameter mom_tool_corner1_radius mom_tool_flute_length
global mom_tool_length tip_angle mom_tool_point_angle RAD2DEG
  if ![ info exists mom_tool_corner1_radius ] { set mom_tool_corner1_radius 0 }
  if { $mom_tool_type == "Drilling Tool" } {
  set tip_angle [ expr $mom_tool_point_angle * $RAD2DEG ]
    MOM_output_literal";(D=[format "%.2f" $mom_tool_diameter]Tip angle=[format "%.2f" $tip_angle]
FL=[format "%.1f" $mom_tool_flute_length]L=[format "%.1f" $mom_tool_length])"
} else {
    MOM_output_literal";(D=[format "%.2f" $mom_tool_diameter]R=[format "%.2f"
$mom_tool_corner1_radius]FL=[format "%.1f" $mom_tool_flute_length]L=[format "%.1f"
$mom_tool_length])"
}

r290684896

不懂，帮忙顶顶。

henry1268

也不知道哪段语句有问题,逍遥男仔,可在?

henry1268

难道因为经济不景气,高手都放假了吗?在线等帮助.{:}