|
|
近日，我在编程时发现，在进给率中给出大于400的值，用UG自带的三轴后处理生成的程序很奇怪，明明在编程时是正常切削路径，可为何却生成G0代码，进给率给的值小于400，后处理生成的程序却能正确的用G1，这到底是什么原因，望各位大侠指教，谢了！ 例
N0010 G40 G17 G90 G70
N0020 G91 G28 Z0.0
:0030 T00 M06
N0040 G0 G90 X60. Y-22.5 S10000 M03
N0050 G43 Z13. H00
N0060 Z3.
N0070 G1 Z0.0 F350. M08
N0080 X45.
N0090 X-45.
N0100 Y0.0
N0110 X45.
N0120 Y22.5
N0130 X-45.
N0140 X-60.
N0150 Z3.
N0160 G0 Z13.
N0170 M02
只修改进给别的操作都没有修改
当把进给改为400后就如下
N0010 G40 G17 G90 G70
N0020 G91 G28 Z0.0
:0030 T00 M06
N0040 G0 G90 X60. Y-22.5 S10000 M03
N0050 G43 Z13. H00
N0060 Z3.
N0070 Z0.0
N0080 X45.
N0090 X-45.
N0100 Y0.0
N0110 X45.
N0120 Y22.5
N0130 X-45.
N0140 X-60.
N0150 Z3.
N0160 Z13.
N0170 M02
|
|
发表于 2012-11-5 13:50:03
发表于 2012-11-5 17:12:30
