本帖最后由 jijiman* 于 2019-9-25 14:21 编辑
Using option file: C:\dcam\config\ductpost\fanucG51Q1-IJK-G54.pmoptz
Reading cutfile records.
1 Records Processed (0 percent complete).
109 Records Processed (5 percent complete).
217 Records Processed (10 percent complete).
325 Records Processed (15 percent complete).
433 Records Processed (20 percent complete).
541 Records Processed (25 percent complete).
650 Records Processed (30 percent complete).
758 Records Processed (35 percent complete).
866 Records Processed (40 percent complete).
974 Records Processed (45 percent complete).
974 Records Processed (45 percent complete).
error NCB0243: Program workplane cannot be reached with current model location.
Location:
object: Program, function: Open, toolpath: 1QWD63
object: ProgramBuilderNC
object: CLDATAReader, function: ReadCLDATA
Complete
各位神人 我在使用PMPOST 將先前可用的 OPT 後處理檔案 轉換成 PMOPTZ 格式 PM在後處理時便會發生錯誤
是否有神人可協助查明原因 或者幫忙修正 感恩!!
附註: 我不曉得為啥不能上傳RAR 文件所以貼上下載網址
https://mab.to/x3HZW1oQk
在HELP 錯誤代碼解釋如下
NCB0243Error messageProgram workplane cannot be reached with current model location.
DescriptionMovement for aligning output workplane with model location workplane is impossible on the option file kinematics. The aligning must be made by table rotation axes and both Z and X axes of the workplane must be reachable.
翻譯如下
错误信息
当前模型位置无法到达程序工作平面。
描述
在选项文件运动学上无法进行使输出工作平面与模型位置工作平面对齐的运动。
必须通过工作台旋转轴进行对齐，并且工作平面的Z轴和X轴都必须可以到达。
| 
发表于 2019-9-25 11:48:23
